SymbioteSynapse

US dollars. I’m in California, which is probably one of the most expensive states to get an LLC but still. Even at $100/year I’m probably not getting my money’s worth. Digital games don’t hold their value unfortunately.

$800/year is a lot to save maybe $1000 worth of games. At least that’s what an LLC costs where I live.

Depends where you live. I live in a desert so humidity isn’t an issue, but dust is. I keep most of my filament in bags just to protect from dust. The only one I actually vacuum seal is tpu. Pla, pla+, and petg all do fine without. If I store it for more than a year though, I run it through the dryer first. Or at least have the dryer running while I print from it.

Make sure you calibrate your e-steps after swapping hotends. I did the same thing on my ender 3 putting on a volcano hotend, and started getting overextrusion. After adjusting the e-steps it was back to normal.

Check for a partial clog. 80% of the time i get that consistency with petg, its because the nozzle is partially clogged. The other 20% is the ptfe tubing is shot. Usually it partially melts and causes underextrusion.

Wet filament could be an issue too, but this is pretty extreme for wet filament.

Jerboa has no ads. Why would i pay $17 a year for removing ads that sync puts on their app themselves? There is nothing that sync is bringing to the table that jerboa doesnt have ad/subscription free.