EVs do not use more energy than gasoline cars, that’s nonsense. The best ICE engine is ~40% efficient plus the losses from braking. Battery electric is closer to 80%. They are only around 10-15% heavier.
EVs do not use more energy than gasoline cars, that’s nonsense. The best ICE engine is ~40% efficient plus the losses from braking. Battery electric is closer to 80%. They are only around 10-15% heavier.
Well everything’s more expensive than the thing you already own. It’s true, most are available in the higher end markets right now, but the Bolt and Leaf are pretty cheap. In the long run, almost all EVs are cheaper than their gas counterparts.
Those drawbacks are endlessly discussed online, to a ridiculous degree. Nothing is universally better, but EVs are almost as close as it gets. If there weren’t several whole industries dead set on preventing adoption they would have been adopted much quicker.
Any plans to add belt printer support?
Significant for me. Not sure if vsync is working.
When I ran ABS I used acetone and a scrap piece to make a glue that worked flawlessly on glass.
Thanks I will have to check it out. I wish it had a flatpak or deb though. I hate appimages.
Can’t say you own any 3d cad software anymore anyway since they all went to subscription only about 10 years ago.
I like their pricing scheme though, because most makers work on open source.
I’ve searched for this and couldn’t find it. They must hide it well. How well does it run on Linux?
Nothing unique about the release, proton gets better and better. There are some games however that will likely never work, because their studio or developer blocks it. Most of these are competitive shooters. As long as you are OK not playing these, any time is a good time.
At least this is about autoimmune diseases which aren’t contagious.
I’m wondering the same, but for the US. I ordered from banggood in years back, but it was hit or miss.
No offense, but I made the list and didn’t include mixing hot ends.
That’s pretty cool and I like the name. Looks complicated, but something that could be added later.
2 shouldn’t have a problem with oozing or cooking since the second filament is not in the hot area.
IDK, thats why I asked.
That’s a cool way of doing it, but it seems like it would be difficult to align. In my case, I am thinking of doing a belt style printer, so that may be even more difficult to engineer.
None of that applies to option 2 or 3 though.
EVs have a High voltage disconnect. I repaired my EV(inverter) with normal hand tools in my garage. I did have to buy a license and tool for flashing the firmware, but this is a problem in nearly every new vehicle, gas or electric.