• LazaroFilm@lemmy.world
    link
    fedilink
    English
    arrow-up
    1
    ·
    1 year ago

    Make sure your filament is dry (new spool doesn’t mean dry) are you Bowden or direct extruder? Lower temp, work on your retraction.

      • LazaroFilm@lemmy.world
        link
        fedilink
        English
        arrow-up
        2
        ·
        1 year ago

        If your filament is wet (means there is humidity inside the plastic, not that it got dunked but it absorbed the air humidity). You can dry it by heating it to a temperature that is lower than the temp that would soften the plastic. You can use a filament dryer or food dehydrator. Do. Not use. Your. Oven!!! (Ovens don’t have temperature management precise enough and will melt your plastic spool)

        To keep your already dried filament, you can keep it in a sealed box with desiccants.

        • imgonnatrythis@lemm.ee
          link
          fedilink
          English
          arrow-up
          1
          ·
          1 year ago

          Ha! The oven?! 😬. Hope that’s not a personal learning experience! I keep mine in bags with dessicants in a cupboard in the basement very close to a dehumidifier. Haven’t had any issues but have been thinking about buying one of these for the cupboard as well: Arm & Hammer Essentials Disposable Moisture absorber https://a.co/d/3b3d4cP

          Curious what people here think - is that just a waste of money (they last 60d)?

          • LazaroFilm@lemmy.world
            link
            fedilink
            English
            arrow-up
            1
            ·
            1 year ago

            All this is good to keep an already dry filament from getting moist. To dry a humid filament, you need heat and air flow to clear the moist air away. Only an active dehydrator can do that.

      • Player2@sopuli.xyz
        link
        fedilink
        English
        arrow-up
        1
        ·
        1 year ago

        Yes and yes. You can either get a specialized filament dryer or do it at extremely low temperatures in your oven (look up a guide for this first)

        • LazaroFilm@lemmy.world
          link
          fedilink
          English
          arrow-up
          1
          ·
          1 year ago

          I really advise against oven. Most cooking ovens aren’t precise enough to stay below glass transition temp.

          • Player2@sopuli.xyz
            link
            fedilink
            English
            arrow-up
            1
            ·
            1 year ago

            It’s definitely risky, but I did do it successfully in a pinch (have a dedicated drying box now)